3D Cutting Board

  • Advertise with us
Project by kyle89 posted 06-09-2014 12:34 AM 2043 views 4 times favorited 4 comments Add to Favorites Watch

My first attempt at a 3D cutting board. I used maple, cherry and walnut woods. Started off planing them all down, then cut them all at 30 degrees. I then cut those sticks into smaller pieces and glued them up. Then glued the pieces all together.

4 comments so far

View MarkTheFiddler's profile


2068 posts in 2955 days

#1 posted 06-09-2014 12:59 AM

Great color combination! It turned out well. You may have a 3D bug!

-- Thanks for all the lessons!

View 731's profile


35 posts in 2410 days

#2 posted 06-09-2014 02:13 PM

i WANT TO MAKE ONE OF THESE SOMETHING AWEFUL! How is the best way to glue this up?

-- 731 - Just because it doesn't kill you, doesn't mean it didn't try to...

View Ken90712's profile


17867 posts in 3956 days

#3 posted 06-09-2014 03:44 PM

I remember my first one thx to one of the Masters on here named Degoose (Larry ) blog. With over 300 boards made and sold now I still like looking at the different attempts and designs… Welcome to the 3d club and great job…

-- Ken, "Everyday above ground is a good day!"

View kyle89's profile


19 posts in 2710 days

#4 posted 06-25-2014 06:57 PM

It was definitely a challenge getting all the angles figured out just right. As far as gluing is concerned I went down to staples and bought a bag of rubber bands and then glued em up piece by piece, and then put the rubber band around them a few times. Heres a great link that helped me out quite a bit.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics