Sound baffle for I-phone

  • Advertise with us
Project by runningCT posted 06-07-2014 02:04 PM 1801 views 6 times favorited 3 comments Add to Favorites Watch

Just a 6” 3×3 with 5/8 inch slot drilled in the top at slight angle. At each end of the slot it is drilled about 3/8 deeper than the middle. This lets the sound out to the wholes drilled in the face. Quick project for those bigger but short off cuts. The wood is teak and it works very well. Been wanting to do this since Rockler came out with the kit to do the same.

3 comments so far

View SuperCubber's profile


1120 posts in 3085 days

#1 posted 06-07-2014 05:16 PM

The iPhone only has a speaker on one side, right? If I’m not mistaken, one side is the microphone and the other is the speaker. Which side depends on the model you have, as they swapped them on the 5, I think.

-- Joe | Spartanburg, SC | "To give anything less than your best is to sacrafice the gift." - Steve Prefontaine

View runningCT's profile


7 posts in 2324 days

#2 posted 06-07-2014 08:27 PM

Not sure,all I know is it does make it louder.

View NormG's profile


6506 posts in 3804 days

#3 posted 06-07-2014 11:43 PM

Wonderful idea

-- Norman - I never never make a mistake, I just change the design.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics