End grain cutting board

  • Advertise with us
Project by TRAVIS21 posted 05-05-2014 03:04 PM 1167 views 0 times favorited 1 comment Add to Favorites Watch
End grain cutting board
End grain cutting board No picture No picture No picture No picture No picture
Zoom Pictures

The wood i used is oak, Mahogany, walnut, maple, cherry, and ash. I Picked out out all the wood. And cut the strips down to the size I wanted them to be. When they were all to size then I put the strips in a pattern and glued it all together. I then planed it flat and cut the board in to 1 1/4 inch strips. Then I took the strips and faced them grain side up, I flipped over every other strip, and glued it together again. I then worked on flattening it with a belt sander and drum sander. Then I routed the sides, used the vibrating sander to make the top smooth, and put 8 coats of mineral oil on it.

1 comment so far

View a1Jim's profile


118136 posts in 4432 days

#1 posted 05-05-2014 03:28 PM

That’s a great looking board cool design,what a lot of work it took to make it look this good.


Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics