LumberJocks

Cherry Refreshment Table

  • Advertise with us
Blog series by pintodeluxe updated 02-23-2014 05:33 AM 2 parts 14459 reads 14 comments total

Part 1: Breadboard Ends and Tusk Tenons

02-02-2014 06:40 AM by pintodeluxe | 10 comments »

Here is my cherry refreshment table which will feature a single drawer and breadboard ends.-----I started by making breadboard mortises at the router table. The mortises are 1-1/4” deep and cut in multiple shallow passes. -----I used a 1/4” spiral bit to center a 3/8” groove in the breadboard ends. I made an initial pass in the standard right to left direction. Then I flipped the board end for end and made a pass from left to right to avoid a climb cut.-----I set up my t...

Read this entry »


Part 2: Drawer and Hardware

02-23-2014 05:33 AM by pintodeluxe | 4 comments »

This is where we left things last time…-----I built the small single drawer with half blind dovetails at all four corners. -----I installed a 9” full extension undermount drawer slide. I use a hardwood shim between the drawer bottom and the slide. I plane the shim to fine tune the fit of the drawer in its opening. -----Drawer installed.-----The drawer bottom is aromatic cedar.-----Here you can see the blocking that was added to receive the drawer slide, and the figure 8 fasten...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com