shop vacuum

  • Advertise with us
Blog series by patron updated 04-09-2010 02:42 AM 2 parts 9920 reads 57 comments total


03-16-2010 02:36 PM by patron | 25 comments »

in an ongoing quest to reach dust removal standards in my shop ( my whole house actually ) ,and scotty still working on the impulse drives , i have been forced to continue working on the vacuum system alone and without the use of the tele-porter , or the virtual simulator , the goal of hooking up the unisaw ,and a floor pick-up , i am making decent progress !right now i am about 5/8’s happening , just awaiting some more dinars to get back to the borg store ,and get more fittings .here i...

Read this entry »

Part 2: down draft table

04-09-2010 02:42 AM by patron | 32 comments »

well here is the next segment , culminating in a downdraft table .i had a 6” tube , that i brought down to and thru the floor ,and under the floor to back up inside my workbench ,as i didn’t want to be tripping over it , or bang it all up i had to change to a 5” tube , as that is the only gate that i had ,so i put a ‘y’ there . and did a take off for any other future tools .!.i cut a rectangle in the top of the workbench , roughly 2’x3 1/2’ ,an...

Read this entry »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics