LumberJocks

"Square" Turnings

  • Advertise with us
Blog series by onefullturn updated 03-22-2017 07:06 PM 1 part 1045 reads 0 comments total

Part 1: Off-Cut Turning #1

03-22-2017 07:06 PM by onefullturn | 0 comments »

I recently posted a project involving a square turning and was asked how it is done. I often use this method to turn small boxes from off-cuts. Let’s start with this piece of spalted maple. It has nice spalting and a bit of spongy wood on one face. That part will be turned away. I start by mounting between centres and truing up the face near the tailstock. With small pieces like this, turning the corners does usually not present any problems. I start with a 1/4 inch bowl gouge to...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com