LumberJocks

oldguy2's Blog

  • Advertise with us
This blog is written by oldguy2 | 69 entries so far

Latest Entry

3 pc.bookcase cabinet series #7: Kreg hole jig 180 mistakes or mine??? Assemble the upper case

07-05-2020 03:39 PM by oldguy2 | 2 comments »

And today we tried a dry fit of the 4 ft by 30 inch upper bookcase. all was going well. using the workmate and any clamps to set the first corner. The half lap joint made is easier and checking the front edge for flush then the other side. I had prepped the bottom which went inside with pocket screws so it is on the bench sideways and that is my long clamp from Harbor Freight ( I thought I would us it for ripping cuts but it did fine here). So onto the workmate for the Shelf check. I knew some polyurathane got in some hole and was checking to clean them out. Now here is LEARNING and BS my drill bit for the Kreg set is a STEP DRILL BIT not a full 1/4 inch fu...

Read this entry »

Older Entries

View all 69 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com