| Blog series by kenthemadcarpenter | updated 12-11-2015 09:35 PM | 1 part | 1052 reads | 1 comment total |
Part 1: My preferred rust removal.
If you own any tools, you inevitable will run into rust at some point, or if you by a used rusty tool, removing rust can be difficult in some cases. Of course there are countless ways to remove the rust, all of them requiring some form or another of good ole fashioned elbow grease. I found in most cases what works well, is Wd40, 60 grit Aluminum Oxide sand paper, and a good palm sander. On my drill press this is all I used, these are the steps1st I took some disposable shop towels and wiped o...
