Jigs #3: Large Curve Jig for ~15' Radius

  • Advertise with us
Blog entry by Keith Kelly posted 01-05-2015 04:42 PM 2334 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 2: Hose Positioner w/ Wood Handscrew Clamps Part 3 of Jigs series no next part

Drawing a line, rough-sawing and sanding a curve wasn’t good enough, and I really wanted to make a good curve with a nice square edge.

Behold, the complex router template contraption that worked perfect. Surely there was an easier way to go about this; if you have ideas about alternatives, let me know in the comments!

These screws were to prevent flexing. Before routing, I added a few dabs of hot glue to the backside of the curved strip, which I think made the screws pointless. In the future, I’d just do the hot glue without any screw backers.

Then, after routing:

-- Keith | Subscribe:

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics