Tool Cabinet #2: Cutting the parts for the doors

  • Advertise with us
Blog entry by Jeremy Greiner posted 02-05-2011 05:38 PM 1638 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 1: Assembling the shell Part 2 of Tool Cabinet series no next part

I would have done this sooner, but I did not have enough pegboard to do all the doors and the lowes by me did not carry 4×8 sheets of pegboard, and the HD by me only had the white pegboard. The OCD nature I wanted all the pegboard to match so I ventured to a borg store a few miles away. Found one that had good pegboard yesterday and I was set and ready to cut out all the parts for the doors.

Below is a video of me dimensioning all the parts needed for the 4 doors of the tool cabinet. It’s fast forwarded again but it’s about 5 minutes long. After watching the video I didn’t really like the camera angle I’ll have to set up the camera in a better place next time. I’m not sure if people like these sort of videos I know a lot of times this sort of thing is cut out, if people like this sort of thing I will continue to make them.

No music in this one it’s longer than the first though if I do keep making these I should look at some royalty free music I can use as backgroun music .. any suggestions?


-- Easy to use end grain cutting board designer:

1 comment so far

View Woodwrecker's profile


4239 posts in 4206 days

#1 posted 05-24-2011 07:28 AM

Man, you are the fastest woodworker I have EVER seen !
Only kidding Jeremy.
That was a very cool video, and thank you for showing it.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics