LumberJocks

DIY Air scrubber #1: Ordering filters and designing

  • Advertise with us
Blog entry by jbswearingen posted 11-24-2019 02:30 AM 379 reads 0 times favorited 0 comments Add to Favorites Watch
no previous part Part 1 of DIY Air scrubber series Part 2: Cut list »

I ordered three 20×20x4 MERV 11 and three 20×20x1 MERV 8 filters to build what I hope will become an efficient air scrubber for my 24×24x12’ shop. I intend on eventually building two, one for each side of my shop. My filters came in a few days ago, so I designed it in Sketchup tonight.

Fan is a 220V 4-speed blower my FIL gave me from a furnace he replaced in a building; he’s an HVAC guy, so I can sometimes score good, used motors and blowers from him.

Case is much bigger than the actual blower, to accommodate the three large filters, but that’s not a problem, as I have a high ceiling and it’ll be out of the way. Over all height is 31-7/8”, width is 35”, and length is 31”. All material is 3/4” plywood.

Opening for blower isn’t drawn as I’ll fit that once I build the carcass and will then trace the blower’s exhaust onto the front face.

I hope to document this build with videos that I’ll post to my YouTube channel.

-- Semper fi, Brad



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com