LumberJocks

A solution for Clamping edge banding when clamps and workbench are too small.

  • Advertise with us
Blog entry by hobby1 posted 10-27-2021 03:03 AM 530 reads 0 times favorited 2 comments Add to Favorites Watch

Here is a shop tip, for edge banding a panel when your workbench or clamps are too small
to accomodate any kind of clamping capability.

I was able to use the bottom side of my table top panel to fasten a couple of screws on each
end so I could make a wedge clamping setup, on a small workspace.

Here is a demonstration of making this jig setup:
https://youtu.be/jbcpcZIundE



2 comments so far

View Arcola60's profile

Arcola60

120 posts in 3666 days


#1 posted 10-27-2021 03:05 PM

Thanks for the neat tip! If you can not screw into the back of the panel a sheet of plywood can be placed below and a cleat can be screwed to it and still use the wedges.
Great idea!

View hobby1's profile

hobby1

353 posts in 3580 days


#2 posted 10-27-2021 10:38 PM

Thanks,
That’s a great tip also.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com