LumberJocks

Modified Paulk Workbench #4: Now I have a workbench and an outfeed table

  • Advertise with us
Blog entry by gmaffPappy posted 05-16-2019 02:58 AM 364 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 3: Finished the Cuts Part 4 of Modified Paulk Workbench series no next part

I used my new Crosscut Sled to cut the legs.

Put the casters on, and the table is done….at least until I get a router lift and make one end a router table.

I am happy to report the table is level. I didn’t expect it to be, with every cut and measure error being compounded throughout the build, but it was. The garage, in compliance to code, has a slight slope to the front of the garage. The table has the same slope, but is totally level side to side. There’s no racking or rocking. Overall, good build. I. Looking forward to using o. The next project… .the Federal End Table.

-- If it's easy to do, you haven't spent enough time over engineering it.



1 comment so far

View badluck's profile

badluck

13 posts in 2957 days


#1 posted 05-17-2019 01:52 PM

Congratulations, I am planning something similar in the future. It looks good.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com