Circle cutting #6: Attaching the bearing and base!

  • Advertise with us
Blog entry by degoose posted 04-26-2009 11:35 AM 2307 reads 1 time favorited 4 comments Add to Favorites Watch
« Part 5: Laminating the blank Part 6 of Circle cutting series Part 7: Finished »

Drill an access hole in the base

Line up the centre of the base using a spacer

Place the bearing over the spacer

Screw the bearing to the base
more next week

-- Don't drink and use power tools @

4 comments so far

View woodworm's profile


14471 posts in 4011 days

#1 posted 04-26-2009 03:34 PM

Ok keep going, I’m following..

-- masrol, kuala lumpur, MY.

View a1Jim's profile


117655 posts in 3998 days

#2 posted 04-26-2009 07:48 PM

Is this a serial blog? tune in next week for the amazing circle cutting jig :)) . I certainly will.

View Beginningwoodworker's profile


13345 posts in 4094 days

#3 posted 04-27-2009 03:13 PM

I would like to see where this ends up.

View Napaman's profile


5530 posts in 4498 days

#4 posted 05-25-2009 10:46 PM

ok larry thanks…I have actually used one just like this…but i only attached the metal piece…i did not attach the smaller wooden circle—-this makes much more sense…

-- Matt--Proud LJ since 2007

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics