LumberJocks

Craftsman Table Saw

  • Advertise with us
Blog series by cootcraig updated 03-31-2015 02:00 PM 4 parts 12852 reads 12 comments total

Part 1: Purchased the saw

02-19-2015 03:38 PM by cootcraig | 3 comments »

Inspired by this video series on refurbishing a Craftsman Table saw, I found and purchased one. Nelson Studios saw refurb Here it is as I was disassembling it on my pickup. The saw disassembled, so I could move it and start cleaning it up. Next up I will clean, paint and polish the wings. I plan to mask the top surface while I paint the bottom with Rustoleum hammered gray spray paint. Then I will clean the top surface and apply Boeshield T-9 and finish with paste wax.

Read this entry »


Part 2: Rolling Base to Build for the Saw

02-21-2015 03:40 PM by cootcraig | 0 comments »

Planning note. The saw did not come with a stand. I plan to fabricate a rollingstand that will mate with my build of Ron Paulks portable bench II. I will adaptthis rolling base for my saw. Rolling Stand Blog Entry

Read this entry »


Part 3: Paulk Workbench II looks good for limited garage work shop

02-21-2015 04:26 PM by cootcraig | 2 comments »

I like to map out things in advance so the will fit at the end. The Paulk Workbench IIwill work well in my limited garage space. I will very limited in saw use until I havea rolling stand for it and I want the saw/stand to mate with the workbench. Hereis the youtube announcement for the Paulk Workbench II. A still to see what it looks like.

Read this entry »


Part 4: Cleaned Up Cast Iron

03-31-2015 02:00 PM by cootcraig | 7 comments »

Here is the cast iron top and wings after clean up and waxing. Boeshield T-9 applied and then rubbed on Carnauba paste wax.

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com