LumberJocks Woodworking Forum banner

Project Information

I made this rolling pin to Compliment the Plaid cutting board. The roller is made of maple, walnut, cherry, and paduck. The handles are walnut with a poplar shaft. The shaft was turned down a 1/16" and finished with lacquer and a walnut recessed button on the end. The roller turns quite freely in the walnut handles. The handles are finished with polyurethane. The roller is finished with mineral oil.

Gallery

Comments

· Registered
Joined
·
199 Posts
Nice!
 

· Registered
Joined
·
585 Posts
Man you pinned that one!

Great looking set!
 

· In Loving Memory
Joined
·
5,826 Posts
You did a very nice job on this rolling pin. Congratulations.
 
Top