Need help! table saw finger joints, large panel size

  • Advertise with us
Blog entry by cdnstudentwoodworker posted 07-08-2014 05:19 AM 1622 reads 0 times favorited 1 comment Add to Favorites Watch

Hello ,during the school year i created and made a box joint jig work. The downfall being it used a deepthroated bar clams as its mirco adjust clamping the jig fence to my miter gauge. Now im bulding a tool box and need do to a finger jointed side , i have no clamps large enough and have seen no clamps large enough to accomdate in the same fashion , the panel is 11×14x1/2”. the 14 inch width is the one recieving 1/4” finger joints. Anyway im looking for any help or ideas on how i can make this work… My previous setup was similar to this one

If I can get any help id really appreciate it! id post or sent a set of machinist chest plans to that person or to the collective lumberjocks community as i had a hell of a time finding them…

1 comment so far

View Grandpa's profile


3263 posts in 3479 days

#1 posted 07-08-2014 06:56 PM

Take some time and build this to suit your needs. I think you will be happy with the results when you are finished.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics