LumberJocks

Woodworking blog entries tagged with 'twin screw'

  • Advertise with us
View Madmark2's profile

Small Projects #28: Dual Bowl Twin Screw II

04-24-2020 08:20 PM by Madmark2 | 0 comments »

The prototype being successful I made five more pipes, one with a special dual bowl design. Five pipes, one with a secret surprise! Starting with a board we progress to functioning pipe blanks. Lovely purpleheart is a full 1” thick The purpleheart was ripped at 3/4” and then recut to 3/4” leaving a 5/32” offcut with a TK blade. The 24” piece was cut at 3-7/8” and yielded six pipe blocks with about 1/4” left over. Talk about 100% yield! ...

Read this entry »


View twobyfour16's profile

Workbench #6: Skirts & Vises

09-05-2012 02:00 AM by twobyfour16 | 3 comments »

So, the top needed skirts, obviously, so time to laminate again. This time, I used 3 pieces of 1×8 black walnut. This gave me a skirt that is 2 1/4” thick, and 6 3/4” wide – after cleaning up the edges. I glued up enough blanks for the front skirt, two end skirts, and chops for both vises. I did not get very many pictures of this process, as I had plenty of lamination pics earlier….I will say that these skirts were BEEFY! And heavy. So, now I had to figure...

Read this entry »


View RS Woodworks's profile

My Ultimate Workbench Build #1: Getting started...

06-30-2011 06:26 AM by RS Woodworks | 1 comment »

This workbench project, for me, has been a long time coming. Well, long as in a couple of years anyways. It kinda began when I finally realized that the piece of plywood on two saw horses wasn’t quite cutting it as a woodworking bench. The mdf top on two collapsible metal legs wasn’t much better, and althought its been my main work, assembly, and glue up table for the past two years, the granite top of my table saw is far from an ideal workbench either. So, slowly, I began accumil...

Read this entry »


View Big Ben's profile

Shop #5: Completed Workbench

02-09-2011 04:44 AM by Big Ben | 10 comments »

I finally done getting the bench together, I beefed up the lower shelf with 2.5” with .5” rabbet for the slats to fit in, I had enough left over scrap to complete the shelf. I did however miscalculate and will not be able store the compressor on it. BUT I did get a Ridgid Band Saw which I may be able to use to store. (Band Saw step will be my next blog and project). I still need to apply BLO finish but I am having to much fun using it to stop now. From Woodworking The lower ...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com