LumberJocks

Woodworking blog entries tagged with 'school bus'

  • Advertise with us
View sras's profile

Toys & Models #5: School Bus Part 5

07-14-2020 03:08 PM by sras | 9 comments »

Took a day off from the build. Then started back at it! Started to drill locations for the lights. Found out I had spaced them too close. Patched the hole and drilled the rest. I wasn’t thinking about grain direction when I cut the end caps for the roof. I had more than one split apart while drilling. Glued and held together with tape. Glued on a filler piece that wasn’t going to be added until later. Added some strength but will require some fitting la...

Read this entry »


View sras's profile

Toys & Models #1: School Bus Part 1

07-08-2020 03:45 PM by sras | 17 comments »

I haven’t done a real time blog in a long time. Time to do one. I’m using my phone for pictures for the first time so we’ll see how that goes… I’m bulding a pair of school buses for grandkids birthdays. The first one starts school this fall. The second one will be given in 2 years. I started with a set of plans from Toys & Joys . The first thing I did was redraw it at half size. After getting the wood cut to the various thicknesses (3/4”, 3/8&...

Read this entry »


View sras's profile

Toys & Models #2: School Bus Part 2

07-08-2020 04:19 PM by sras | 10 comments »

I pre dyed the radiator parts to keep colors from bleeding. A few details got altered with the half-size design. One alteration is I needed a small relief in the hood for tire clearance. After building up the hood blanks I cut the relief in each side. Then add the radiators Next up was the fenders. I decided to make headlights from some stick on “pearl” decorations I got from a craft store. I needed to cut them to size. The first couple took ...

Read this entry »


View sras's profile

Toys & Models #3: School Bus Part 3

07-09-2020 12:07 AM by sras | 16 comments »

Next was framing the windows. I should have taken a few more pictures here. There are a few steps covered by this photo. The blank on the lower right was the first step. The dados on each end and the center were made with the router table and the narrow dado was done on the table saw with a 1/16” kerf blade. This blank was used to create the strips in the center of the picture. Each of these strips consists of 2 window posts. The last pieces are the corner posts. The dado i...

Read this entry »


View sras's profile

Toys & Models #4: School Bus Part 4

07-10-2020 11:32 PM by sras | 16 comments »

These last 2 days involved lots of hours, but not much to show for it. Quite a bit of time spent adjusting fits. I clamped the sides to the floors so I could get the fronts, backs, and side door fitted. The backs were cut to size and a groove cut for the door outline. Saw blade set at 45 degrees was the set up. The window openings were cut into the sides The side doors got a center groove And then cut to size Holes drilled for internal windows And ...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com