03-04-2012 07:07 PM
by chopnhack |
6 comments »
The mobile workstation is in my opinion going to be the center of my workshop once its built. An integrated router table, table saw, downdraft table and ample storage in a ~ 5’ x 2’ area on wheels! Certainly not my idea, however, the layout will be done solely by me. I am open to all suggestions though, so please feel free to brainstorm here and let me know what has worked for you, what you would do differently if you had to build one again, etc. All comments and suggestions are w...
Read this entry »
03-19-2009 04:18 AM
by raf |
5 comments »
Made some progress the past couple of days. Started building the cabinet for the right side of the saw. I had two drawers that were intended for another project, but they were the wrong size so I’m using them here. I built the cabinet to fit the drawers and added a smaller top drawer.
No drawer slides yet…Gotta go buy those still. I was amazed (not in a good way) at the prices for the full extension slides. Once I started adding them up, I had a little sticker shock. But I gues...
Read this entry »
03-16-2012 11:44 PM
by chopnhack |
1 comment »
Ok, so it’s much more fun to dance than to fix…. Apparently welding a frame should not be undertaken without proper support, or ahh… more experience. The frame had a twist to it across the 59.5” length!
I cleared a section of the shop floor (miracle) got out my door installation level and found a fairly level area. I then proceeded to use some shims to adjust the floor until the it was perfectly level. Gotta give credit to the guys that screeded the floor some 50 y...
Read this entry »
