06-26-2012 04:46 AM
by sandhill |
1 comment »
As I mentioned in the last comment of part 1 I am not going to place the router into the cabinet with the table saw so I moved on to the out-feed table. Its a real simple set up 3/4” Birch ply with a 3” oak border and oak stiffeners ever 12” the legs are 3/4” plywood as well. I removed the angle iron on the out feed side of the saw that’s part of the Biesemeyer 54” fence and used the bolts to secure the out-feed table to the saw and 2” screws ...
Read this entry »
01-13-2011 05:13 PM
by Chris Davis |
9 comments »
I am trying out a new video feed. The service I was using before and have been using for years just kept adding ads and then got to the point to where they’d put a commercial on the videos and the feed at start-up. Most of the commercials I didn’t like. I felt they were inappropriate. One car company ad kept using foul language, even though it was being bleeped It was still known what was there.
I even tried to trick the system into using more kid friendly ads by putting ta...
Read this entry »
10-10-2010 02:46 AM
by PurpLev |
14 comments »
As mentioned in a previous post, I was in the midst of planing quite a bit of hard maple, when my planer decided it was not hungry anymore, and would not feed the lumber under any circumstance – I tried the “here comes an airplane”... no go. I tried the “I’ll get you ice cream if you finish all the lumber” – nope. I tried “I’ll tell mama you didn’t finish your wood” – nada.
So I decided to play doctor and open it up an...
Read this entry »
