LumberJocks

Ash Scraps = remote tote

  • Advertise with us
Blog series by bandit571 updated 04-22-2019 01:08 AM 2 parts 801 reads 2 comments total

Part 1: Start up

04-17-2019 10:17 PM by bandit571 | 0 comments »

had more than enough scraps left over….made 2 glued panels….then got them to match each other…then a bit of bandsaw work, to do a few curves.. laying off the the left…had two others that seem wide enough to use as sides, without any glue ups…laid out for some dovetail pins.. Wood is 5/16” thick Ash. A bit of backsaw work, a bit of chisel work… We have pins….used these to lay out the matching tails….then try to stay on the wast...

Read this entry »


Part 2: Design change, then a PIP

04-22-2019 01:08 AM by bandit571 | 2 comments »

Had to get this thing done…didn’t have any trouble cutting pins… Same as before…spaces for 4 tails.. Was even trying out a new chisel… Even ran a plane across the side… to flatten a bit of cup going on.. Problem arose with cutting the tails…. Grain direction…tails were snapping off, during the dry fits…finally decided to just buzz the dovetails off,,,and get out the nails and glue.. Cut a 5mm plywood panel to rough size, ...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com