LumberJocks

A Shaker Style Table, 2022 version #11: dados, and a dry fit

  • Advertise with us
Blog entry by bandit571 posted 05-09-2022 01:48 AM 582 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 10: Drawer build, part 1 Part 11 of A Shaker Style Table, 2022 version series Part 12: Monday, busy Monday »

Had to figure a way to hold the drawer side still, while milling a dado..

A stop block and a pair of clamps…score across, then handsaw down to depth….and use the stanley 45 to get roughly to depth…there was an issue with the 45 wanting to tilt a bit…

Used the Stanley 71-1/2 to level things up….couple dry fits…to get the back to size..was to wide in both directions..finally..

Checked for square..

I thought I had a plywood panel on hand….just wasn’t wide enough..grrrrr, quick trip to Lowes, buy a 1/2” x 24” x 24” plywood panel….then size it to fit..

Tomorrow..prep to glue this up….even have a small wood knob, and the proper screws for the corner blocks

Might take a day or two…before any finish can go on…

Stay tuned..

-- A Planer? I'M the planer, this is what I use



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com