LumberJocks

Ash Scraps = remote tote #1: Start up

  • Advertise with us
Blog entry by bandit571 posted 04-17-2019 10:17 PM 524 reads 0 times favorited 0 comments Add to Favorites Watch
no previous part Part 1 of Ash Scraps = remote tote series Part 2: Design change, then a PIP »

had more than enough scraps left over….made 2 glued panels….then got them to match each other…then a bit of bandsaw work, to do a few curves..

laying off the the left…had two others that seem wide enough to use as sides, without any glue ups…laid out for some dovetail pins..

Wood is 5/16” thick Ash. A bit of backsaw work, a bit of chisel work…

We have pins….used these to lay out the matching tails….then try to stay on the waste side of the lines…more chisel work…then a dry fit, to see how good, or badly things fit..

Hmmm, need more practice….got the next corner done..

getting a little better each time….also shaped a handle…

need to cut a tenon on each end…maybe round the edges a bit more…back was having “issues”, didn’t even clean the bench up..

Next time to the shop ( laundry Detail, again?) I need to do the other two corners, and chop two through mortises for the handle’s tenons. Then see about a glue up? May build a set of dividers, sized to fit most TV Remotes, and add them? 5mm plywood bottom will get glued in place….

Stay tuned….( may also do a blog about that Front Porch rebuild, if anyone wants?)

-- A Planer? I'M the planer, this is what I use



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com