LumberJocks

A Stepback Cupboard build #11: Face frame, and a bit of assemby work..

  • Advertise with us
Blog entry by bandit571 posted 01-25-2018 07:09 PM 540 reads 1 time favorited 1 comment Add to Favorites Watch
« Part 10: Shelves, and a top shelf Part 11 of A Stepback Cupboard build series Part 12: Bookcase needs a door »

Maybe even a PIP?

Got the parts for the face face milled..

Jointed the edges. Milled some tenons..

That I thought were correct…..was a bit too much tenon….
Chopped a few mortises…

Until I could do a glue up..

Later, came back and tried a dry fit to the front of the case…case was wider than the frame….added a thin strip along the outside edges. Drilled a counter bored holes. Marked out, and drilled counter bored holes to attach the top.

marked radius on the front corners of the top. Ran a cove bit around both ends and across the front of the top….on the underside.

Attached the top with a few screws…will need to plug the counter-bores with more Walnut plugs. Attached the face frame, using a few screws…

Added a pair of cleats..

To attach the bookcase to the lower case…..

Two screws into the sides of the bookcase. Step back a ways, inorder to get the entire project into the picture..

PIP
Yep, going to be a tall one. Need to start building the raised panel door, next.
Stay tuned….

-- A Planer? I'M the planer, this is what I use



1 comment so far

View Ron Aylor's profile

Ron Aylor

2649 posts in 1066 days


#1 posted 01-26-2018 12:33 AM

Looking good as always, Bandit. Keep up the good work.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com