bandit571's Blog

Older Entries

• A Shaker Style Table, 2022 version #12: Monday, busy Monday - 05-10-2022 02:31 PM | 2 comments

  Normally, the shop is closed on Mondays…but..decided to take a chance, anyway..first, I fig...

• A Shaker Style Table, 2022 version #11: dados, and a dry fit - 05-09-2022 01:48 AM | 0 comments

  Had to figure a way to hold the drawer side still, while milling a dado.. A stop block and a p...

• A Shaker Style Table, 2022 version #10: Drawer build, part 1 - 05-08-2022 05:28 AM | 0 comments

  Had aGulley-washer roll through…which sometimes means… That the Dungeon Creek will...

• A Shaker Style Table, 2022 version #9: Doing a little assembly - 05-07-2022 01:31 AM | 1 comment

  Time to knock apart that dry fit…clean a few things up, and a bit of a glue up Things th...

• A Shaker Style Table, 2022 version #8: Mortises, lots of them - 05-04-2022 08:57 PM | 1 comment

  I guess the socket a dovetail’s tail goes into could also be called mortise? Lunch was goi...

• A Shaker Style Table, 2022 version #7: Tenons next - 05-04-2022 02:13 PM | 0 comments

  There are 3 aprons…the 4th (front) will be a drawer. Aprons needed a tenon on each end...

• A Shaker Style Table, 2022 version #6: Working on that top,part 2 - 05-03-2022 01:02 PM | 0 comments

  Ok…Top is back out of the clamps…needs the glue joints cleaned and leveled up.. Ar...

• A Shaker Style Table, 2022 version #5: Working on that top - 05-02-2022 02:32 PM | 2 comments

  When last seen, it was just 4 planks glued up.. Time has come to clean it up…and trim it...

• A Shaker Style Table, 2022 version #4: taper the legs - 04-30-2022 02:05 PM | 2 comments

  I guess to be considered “Shaker Style”....legs need to have tapers done…so ...

• A Shaker Style Table, 2022 version #3: Legs, just..legs - 04-29-2022 02:10 AM | 1 comment

  First, I need to rip some blanks about 20” or so long. I had the 2 cut-offs from the top&...

View all 857 entries »