Poker table

  • Advertise with us
Blog entry by VonlederHosenschnitz posted 04-21-2015 01:13 PM 986 reads 0 times favorited 0 comments Add to Favorites Watch

This is my poker table design and build process, to start off I cut 8 pieces at 21 inches and cut them at a 22.5 degrees. After doing that I created a system to cut a 3 in hole in all 8 pieces exactly the same. I will be posting more as the process of the project goes on! Stay in tune and i think you will enjoy the outcome.

For the next step I drilled holes on all 8 pieces so I could sink a screw into the pieces. I do this so the 8 pieces will be held together well when I am ready to assemble my table top.

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics