Waterfall slab #1: Joining two slabs at endgrain

  • Advertise with us
Blog entry by Tmanpdx posted 06-06-2019 10:11 PM 787 reads 0 times favorited 0 comments Add to Favorites Watch
no previous part Part 1 of Waterfall slab series Part 2: How to cut a waterfall slab with no straight edge »

Before I get to the waterfall, I needed to join two medium sized (3.5 ’ long each) together. As the slabs were cut from the same tree, my hope was a symmetrical result.

Note: All this was done on my CNC

First I need to cut out the butterflies:

Then I need to position / place the butterflies

Now I get to cut the spline

And then glue the spline

Then cut out the butterflies

And glue them in

Not shown: Flipping it over and doing it all over again!

End Result – sanded

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics