Stickley 802 Hall Table #7: insides

  • Advertise with us
Blog entry by TigerTed posted 06-09-2019 11:21 PM 547 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 6: Shaping Part 7 of Stickley 802 Hall Table series Part 8: Drawer Making »

Forgot to mention the tapering that was done. Used home made taper jig on the bandsaw. Cleaned up faces with plane. Lot of plane work. Used off cuts as cauls during glue up. They were taped on with blue tape.

Added frame for drawers. Mortise/tenon. Same stuff done here. Sneak up on width with plane to just slip into case.

Then we glue to the front carefully making sure it’s flush.

drawers started by cutting pieces to barely fit opening tight and hand plane to slide (.010” clearance).

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics