LumberJocks

Stickley 802 Hall Table #3: Panels

  • Advertise with us
Blog entry by TigerTed posted 01-07-2019 05:26 PM 476 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 2: Rough work Part 3 of Stickley 802 Hall Table series Part 4: Rough Joinery »

Chose the best 5/4 stock for the top. 18” wide. Left over 8/4 was resawed (previous post) and used to make side panels and bottom shelf. These were glued up.

Of course, there was a ton of hand planing. Flatten show side. Marking gauge to max dimension that will clean up the opposite face and plane.

The top was cut to length with a miter saw guided by a Veritas magnetic guide. I make sure the tool is square using a 12” square.

I did find some cracks in my stock. Decided to fill with 2 part epoxy. Maybe that’s a waste of time but hate to waste the wood. I wanted to preserve the wood because it all came from one board and would be difficult to match.



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com