LumberJocks

TigerTed's Blog

  • Advertise with us
This blog is written by TigerTed | 23 entries so far

Latest Entry

Stickley 802 Hall Table #5: Drawer Divider

02-25-2019 12:24 AM by TigerTed | 1 comment »

This is where I left it. Been too busy… This table has two drawers. A divider is needed. I chose to use a double ended sliding taper dovetail joint. The joint must be accurate as it is highly visible. The first divider I made was scrapped. One dovetail end was not long enough. Somehow I didn’t mark lengths properly from the case. Once the shoulders are a good fit, I used a taper jig to guide my chisel. Because the jig warped since last time I used it, I spent 20 minutes rehabbing the jig. After the dovetails were looking good, I used it to mark out the sockets in the case. I cut the sockets carefully to get a nice tight fit. Not bad. Next time, ...

Read this entry »

Older Entries

View all 23 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com