LumberJocks

Sean's Favorites

  • Advertise with us
View mafe's profile

Card scrapers #1: MaFeBurnisher (scraper set up tool) Blog updated 4oct2010

10-04-2010 12:42 AM by mafe | 28 comments »

MaFeBurnisher BLOGscraper set up tool Ok I posted the project, and here are the blog, since there seems to be some wishes for that now… If there are wishes, I’ll make a work drawing with measures, but I think it’s quite ‘out the road’.(And thank you, I’m better today, so I could spend a little quality time in the work shop 2×40 min.). The project comes from different ideas I have seen around, and the fact I’m not all happy for my VERITAS...

Read this entry »


View ~Julie~'s profile

Workshop Build #16: The Lumber Rack

05-05-2010 04:34 PM by ~Julie~ | 31 comments »

Planks on the Floor, Planks on the Floor,Lookin’ Like a Fool with yourPlanks on the Floor… Sorry, just had to do that… My small collection of pine was sitting on the floor, waiting for somewhere nice to go: This wall was the decided place, it allows me to enter the open garage door on the garage side of the workshop with a load of wood and then bring it through the middle door that divides the garage from the workshop: I decided to use 2×4 uprights screwed t...

Read this entry »


View lew's profile

Kitchen Treasures #1 Making the Celtic Knot Rolling Pin #5: Update

08-02-2009 11:53 PM by lew | 17 comments »

The other day, I posted another rolling pin. There have been several requests about how to make them. I thought I should update this tutorial with the new and improved trimming jig. Top of jig- hold down clamps, handle, and cutout. The cutout is the main new part to this jig. Previously I was using my tapering jig. The problem I encountered was that if the trimming process was not perfectly flush with the pin blank during the first trimming operation, then the blank would not clamp fla...

Read this entry »


View Kent Shepherd's profile

Spiral End Mallet #5: The Mallet Itself--Final Chapter!!!!!!!!!!!!

08-24-2009 10:17 PM by Kent Shepherd | 16 comments »

So, by now you’re asking—Mallet, what mallet? Really, there is a mallet. Amazing, I could spend 4 sessions showing you how to make a little 2” disk. The good news is, that was the Hard Part. I’m assuming if you’re going to actually make this project, you already have a lathe and know how to use it. If you depend on me to teach you to turn, we’re both in trouble. My experience is rather limited in this area.. That said, you’ll see how basic this part r...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com