Scott and Jay's "Shop Time Throwdown" #13: Final steps and the REVEAL VIDEO!

  • Advertise with us
Blog entry by MyGrowthRings posted 04-06-2015 08:00 PM 1547 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 12: Finish the hands Part 13 of Scott and Jay's "Shop Time Throwdown" series Part 14: Final Entry and the Secret to How the Clock Works. »

Note: Don’t miss the link to the video at the bottom of the post!

The final steps happened in a blur over the Easter weekend. The big reveal was pushed back to Easter day, 4/5/15 and because of the reprieve I did what I always do: procrastinate. So while the photos in this post are sparse the payoff will make it worthwhile.

Using my Shopsmith bandsaw I resawed a 22” length of 2X4 and freehand drew a capital “I”, “V” and “X”. Drawing isn’t a skill that I was blessed with, so I was thankful to be using Roman numerals. After a quick count I was surprised to learn how many time the number “I” appears on a clock dial. Can you guess without looking? I traced these onto the pieces of resawn pine and cut them out on my bandsaw and gave them a couple quick coats of paint.

Fortunately I happened to have a paper dial laying around, so I cut a hole through the center and taped it to my large dial and using my compass to extend the lines to the “number ring” area of the dial. Again I used the Titebond HiPur hot melt to tack the numbers in place, and if any of them ever spring loose I’ll tack them all with my 23Ga pinner for good measure.

As almost an afterthought I did a quick angled rip on my bandsaw on a 2X4 to serve as a cleat for mounting the clock, and I used liquid Nails and a couple TapCon scews to hold the lower cleat in place on the wall and gave it a few hours to cure.

After trying to lift the behemoth myself i called my son “Boy” to my shop and we lifted her into place and recorded the following video. Please note that the next and final post will contain a video that explains how the clock functions.

-- and

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics