Scott and Jay's "Shop Time Throwdown" #6: Time to install some bearings, then suddenly... CRAP!

  • Advertise with us
Blog entry by MyGrowthRings posted 03-20-2015 08:39 PM 1660 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 5: Jay Dighsx posts his week 2.5 update video Part 6 of Scott and Jay's "Shop Time Throwdown" series Part 7: One of the most uncomfortable things I've ever done with a woodworking project »

I’m to the point in my project where I need to mount some bearings, so I picked-up some skateboard bearings off of Amazon that had a good rating at that weren’t going to break the bank. I only need four, but they were sold in sets of eight, so I guess I have back-ups. The ID on them is 8mm, and after a little research I determined that what I needed was a couple 8mm X 100mm steel dowels. I dropped by our local Fastenal store and though they didn’t have them on hand they were able to get a pair ordered for pick-up in the store two days latter for only $2 each.

Like clockwork (see what I did there?) they called two days later and after paying and jumping back into my van I was able to confirm the fit… and they don’t fit! This can’t be happening! They were oversized and after looking closely at the invoice I noticed that the word “Oversized” even appeared in their description! I didn’t ask for oversized dowels, I asked for 8mm dowels! Shouldn’t this have been mentioned when I ordered them?

So as you can see I had to toss them on the lathe and turn off a small amount to permit the bearing to slide on. If I knew I was going to have to do this I would have walked out the door on Monday with two 3/8” dowel pins.

My next challenge was I would need to mount the bearings in a couple 22mm holes, and wouldn’t you know, that’s not a common size even in European cabinetmaking, so it was back Amazon. I snagged this carbide tipped “Forstner” for less than $6 with free shipping thanks to Prime. And yes, I know these bits aren’t truly Forster bits, but seeing that I’ll be drilling on a drill press and all the holes are square to the face of the board they’ll do just fine.

-- and

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics