MikeDe's Forum Topics

  • Advertise with us
View MikeDe's:homeworkshopprojects (32)blog (3)reviews (0)forum topics (6)buddies (2)favorites (85)activity logWatch
03-18-2019 01:01 AM

Primer for plywood edges - 8 replies

I am building a kitchen cabinet for my daughter out of birch plywood that I will be painting And I was wondering if there is any kind of primer that will do a good job covering up the edges of the plywood before I put the final paint on it

02-19-2019 05:21 PM

What glue to use - 3 replies

I am replacing some veneer on a cabinet and the use of contact cement won’t work, because I have to move the veneer a bit to get the fit that I need. Is there any cement that anyone knows about that will allow this movement I need. I use Franklin Titebond on all my woodworking projects so I call them and they said their ...

09-20-2017 01:50 AM

Bad finish on bebch - 2 replies

I restored a Garden Bench and it came out greatI sandblasted the cast iron sides and back insertand replaced the wood with White oak. For thefinish I was told to use Watco Teak Oil When it was finished it looked great.And the great look lasted until the first rain,A very light rain, that only got the seat slates wet.After the rain I checked it a...

02-18-2017 07:18 PM

Table saw blade won't go back to 90 degrees - 7 replies

I am having trouble getting the blade back to 90 degrees on my Delta Table Saw after tilting the blade for an angle cut. When I get close to 90 the wheel gets hard to turn, and it seems to have something, like saw dust in the way that will not let it come to a stop.

03-21-2013 10:55 PM

Need help finding the right glue - 4 replies

I just planned some pine boards down to just under 3/4 inch. I am going to cut them to the finial size before I finish planning them to 1/2 inchThere are some knots in the wood and I know that sometimethey can come loose. What I would like to do is apply someglue to hold them in place. I use Titbond glue and it is to thickto get around the edge ...

01-26-2013 04:08 PM

Dust Collection - 4 replies

I am building a dust collection system for mytable saw. I have it just about complete, allI have left to do is to build a blade guard witha dust port. I can build one with a 3 inch or 4 inchport in it and I would like some feedback on witchwould be the best size.The system starts at a 6 inch line from the cycloneand ends with a 4 inch line at th...

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics