LumberJocks

Coffee table

  • Advertise with us
Blog series by Markymark updated 05-06-2016 07:33 PM 4 parts 3769 reads 5 comments total

Part 1: Starting the project

04-10-2016 01:10 AM by Markymark | 2 comments »

I started by my project by opening the book to the materials list. Then grab a board of oak and cut it down to make the rales.

Read this entry »


Part 2: Progress 3

04-22-2016 11:40 PM by Markymark | 0 comments »

I jonted three prices of wood and glued them side by side. Then I cut it too get both my end aprons. Instead of doing the Mortis and tenseness, to save time I used a tool to drill holes at a angle, to screw to the legs.

Read this entry »


Part 3: Progre 4

04-30-2016 12:09 AM by Markymark | 3 comments »

This week I used the band saw to cut an angle on the lags. Then sand the cut part flat with the belt sander. Then the lags and end aperons flat on the table. Then lined them up and score them together. Then turn both parts on the side. I grab the rail and lade it flat. Then level the two parts with the rail and screw them together. Then measured the bottom part of the railing 4 inches down to screw the lower railing.

Read this entry »


Part 4: Progress 5

05-06-2016 07:33 PM by Markymark | 0 comments »

I screwed two middle stilts in. Then I grab the two rails that I made earlier and used the band saw to cut two corners out. Then drilled four hole for the screws. Then lined them up the top of the bottom rail screwed them in. Then I clapped the bottom middle stilt to holed in place and screw it in.

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com