LumberJocks

Small Projects #17: Glass Pipe Accessory Stand

  • Advertise with us
Blog entry by Madmark2 posted 02-27-2020 12:26 AM 254 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 16: Jatoba stash box Part 17 of Small Projects series Part 18: Devlin's First Tool Box »

My customer sells a variety of pipes and smoking accessories and needs various display stands for the oddly shaped bits and bobs.

It’s a ‘whatzis’ stand

This is the second stand I made for them. The first was similar but had three rows of 1/2” posts whereas this version has two rows of 3/4” posts. I dropped off the first one yesterday and my customer was so pleased they immediately ordered the 2nd one.

The beveled edge detail is common to both stands as is the 10-1/2” width. The bevel was cut 3/8” x 45° with the 1/2” 3-1/2 hp Milwaukee table router.

They both have the makers mark and felt feet on the bottom. No scratching the customers counters.

I had a rubber stamp made – LOTS cheaper than a branding iron and no warm up!

They are finished with two generous coats of Johnson’s Paste Floor Wax and lightly hand buffed.

They each took and hour or so to make and cost about $5 in clear pine and dowels.

-- The hump with the stump and the pump!



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com