LumberJocks

Small Projects #6: Dog Feeder

  • Advertise with us
Blog entry by Madmark2 posted 01-27-2020 01:26 AM 293 reads 0 times favorited 2 comments Add to Favorites Watch
« Part 5: Tall Dog Gate Part 6 of Small Projects series Part 7: Clamp Stand »

Dogs! We have two sizes, small and bigger. Roscoe is an English bulldog who doesn’t like to share with the other, smaller, dogs. Due to extreme inbreeding Roscoe can’t eat if the bowl is flat on the floor. The better half had been holding his dish by hand twice a day until I built this simple dog bowl stand.

It’s just at the right height for him. It was built out of some 2×10 and 1×12 scraps. I beveled the corners of the sides to make it less of an ankle biter.

I didn’t have a compass (or I have one but couldn’t find it) so I had to lay out the circles with a ruler. I marked the center and then radius marks every 45° or so and hand connected the segments. The result was a little ragged in spots but all is covered by the bowl lip.

-- The hump with the stump and the pump!



2 comments so far

View BB1's profile

BB1

1588 posts in 1488 days


#1 posted 01-27-2020 02:38 AM

Looks like he likes it! Always nice to be able to build what you need (with custom height, etc). Nice!

View LittleBlackDuck's profile (online now)

LittleBlackDuck

3677 posts in 1460 days


#2 posted 01-27-2020 11:40 AM

Where’s the napkin holder?... even before we start discussing the salt and pepper shakers!

-- If your first cut is too short... Take the second cut from the longer end... LBD

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com