With the boards milled and cut to length, it was time to assemble the face frames. I used a Kreg pocket hole jig to drill the holes for the frames. Not just any jig but my modified jig. It works great! I have to stay focused and keep my fingers out of the way. :-)
Then I laid out the pieces and clamped them to my work bench/assembly table. A few screws later and VOILA! a completed frame.
Rinse, repeat three more times, and the four frames are ready to go.
Next phase, raised panel door and drawer front construction. Pics coming soon.
-- Handcrafted by Mike Henderson - Channelview, Texas
2 comments so far
Vince
home | projects | blog
1334 posts in 4879 days
#1 posted 03-31-2014 05:48 AM
Nice jig setup and the parts are looking good too.
-- Vince
MT_Stringer
home | projects | blog
3183 posts in 4681 days
#2 posted 03-31-2014 06:10 AM
Thanks Vince.
-- Handcrafted by Mike Henderson - Channelview, Texas
Have your say...