JonK's Blog

  • Advertise with us
This blog is written by JonK | 2 entries so far

Latest Entry


03-19-2013 02:56 AM by JonK | 4 comments »

Ok, with past entries and wisdom from LJ pros I was able to get the jointer I could afford. I located a older Craftsman contractor jointer for a good price on-line and brought my new tool home to set it up. The tool was well taken care of but the blades were rusted to the blade chuck so, with every unsuccessful effort to remove the blades with directions found in the manual I had to disassemble the part. This means taking out the arbor and bearings. Quite the job!Now that I have everything to reassemble the tools insides I have found that the arbor is not fitting thru the bearings. So here is my question: Do I need to have the bearings (bearings are factor specification) pressed on or ...

Read this entry »

Older Entries

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics