LumberJocks

table and miter saw table

  • Advertise with us
Blog series by Holbs updated 11-24-2014 01:23 AM 5 parts 15262 reads 7 comments total

Part 1: Table saw and miter saw mobile stand

11-14-2014 04:18 AM by Holbs | 1 comment »

getting some framing done for yet another mobile combo stand.the miter saw will be flush with the table saw so that it can use the table saw fence as helper fence. It is also on a fliptop to be out of the way for the table saw and soon to be constructed outfeeds. Unsure if i will use my planer/jointer feed tables or make a new one.

Read this entry »


Part 2: dry fit, nearly there

11-16-2014 04:47 AM by Holbs | 3 comments »

gots the dado’s all done.gots the blade storage all done.have the cavities for future shelves, all done.tomorrow, will flush the table saw to the miter saw, fine tune the dust collection system, and glue up.FYI: the miter saw is flipped upside down with the 2 4’ outfeed tables from my planer/jointer stand in place during dry fittings.

Read this entry »


Part 3: accessory mount

11-17-2014 01:22 AM by Holbs | 0 comments »

didnt get too much done today. darn NFL and house chores! but i did put together a home for table saw inserts and taper jig. i am debating to add pull out drawers or not. unsure if they are really needed.

Read this entry »


Part 4: ducting, downdraft table, and drawers

11-23-2014 09:48 AM by Holbs | 3 comments »

all roughed in and messy, but coming together. I have a 6” main feed into a 6×6x6 wye that will spit off to downdraft table and then a 6×5x4 (5” goes to bottom of saw, 4” will be reduced to 3” for overhead dust collection on saw). spent 3 hours drilling holes for downdraft, still have to do baffling.

Read this entry »


Part 5: sunday's ventures

11-24-2014 01:23 AM by Holbs | 0 comments »

Finished off the downdraft table, as pictured from underneath with silicone, baffle, and glue up. You can see the 6×5x4 wye with the 4” capped off. That will be for future addition of overhead saw dust collection. Thru the coming week, still have to seal the ducting seams with grey goop stuff, flush the table saw to the miter saw table, close up air leaks from the saw table, afix something on the wall to hold up the 4’ left miter saw outfeed table, and find a way to have t...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com