LumberJocks

Porter Sander 121 OSS - table saw right extension home

  • Advertise with us
Blog series by Holbs updated 04-10-2017 03:46 AM 3 parts 4501 reads 4 comments total

Part 1: insert plate cut out and bolted to PC 121

04-03-2017 03:34 AM by Holbs | 3 comments »

Installing my Porter Cable 121 OSS into my Unisaw right side extension table. This will be my OSS sanding station / down draft table.I needed a home for this PC121. I considered on the wall via french cleats, dedicated table, or a pull out drawer under my Grizzly combo sander station. To save space, I went with installing it in the extension table just as folks install their router station there. I was unsure of the spindle centering point so went with dead center middle between rails whi...

Read this entry »


Part 2: Making "Y" shaped under table air flow cabinet and adding levelers

04-09-2017 05:21 AM by Holbs | 1 comment »

Letting my under right extension wing air flow cabinet sit the night with glue dries. This measures 36” long x 26” wide. I installed my last 6” blast gate (which I have saved for this project) cutting the tabs 1” and bending them outward with screws to hold them down. I also added the amazing Kreg insert levelers. So far so good.

Read this entry »


Part 3: Nearly 800 holes later...

04-10-2017 03:46 AM by Holbs | 0 comments »

I think I should of researched about drilling holes in laminate tops. Either way…went through 2 new 3/8” forstner bits to make 800+ holes in my right extension table. Took most of the day! One starts to get hot, I toss into bowl of water and use other one.

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com