Slab Table #2: Slab Table #1: Slab Table......pt 2
Not a major update. The maple slab has been sitting a couple weeks since I planed it down. It has dried out a little more, few more cracks have formed, one major one as you can see in the bottom middle of the picture. I was going to run it through a wide belt sander at the local lumberyard but haven’t made it yet. So I finally went to town on it with a big buffing type sander and then normal sanding down to 220 grit. This just has thinner on it to show how it would look. So some concerns/questions: 1) Putting a straight edge on it right now, it is cupped in the center by about 5/32nds. Do I run it through the router planer again or leave it? It’s going to be on ...