LumberJocks

Trestle Table #24: Cut Curves and Planed the Mill Marks

  • Advertise with us
Blog entry by HappyHowie posted 10-28-2016 02:58 AM 1190 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 23: Next Step: Shape my Leg Parts, Then Glue-up Part 24 of Trestle Table series Part 25: Leg Assemblies »

Today I cut the curved leg parts at my bandsaw.

With my Wood River low angle block plane I removed the saw marks. The burn marks were done with my 1/4” bandsaw blade. I replaced it after cutting my first leg part; a foot. I replaced that blade with a 1/2” Wood Slicer bandsaw blade for my 17” Grizzly G0513ANV bandsaw.

I was pleased to learn that I could use my leg taper jig for tapering the legs for this trestle table. I placed blue painter’s tape down on the surface of my table saw along the edge of the taper jig. This was so I could determine the position of the jig to cut my leg’s taper. It worked well for me.

I used the off cut to position the second cut on the leg without me being required to re-position my table saw’s RIP fence.

Tomorrow I will plane each of these parts plus use my spokeshave to shape bevels on the leg assembly parts.

-- --- Happy Howie



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com