Roll Around Tool Cabinet #7: Frame Parts: Grooves and Stub Tenons

  • Advertise with us
Blog entry by HappyHowie posted 01-28-2017 07:14 AM 1588 reads 1 time favorited 0 comments Add to Favorites Watch
« Part 6: Face Frame Attached and Plugs for Countersink Screw Holes Part 7 of Roll Around Tool Cabinet series Part 8: Cut 1/4" Panels and Dry Fit Frames and Panels »

The last few days I have been milling and producing the frame parts for this frame and panel construction tool cabinet.

The frame and panels are placed on the back of the case and the four doors on the front on the case; the two small doors on the top that cover adjustable shelves and the two large or long doors below. Inside these two long doors are seven drawers on the right side of the case and several adjustable shelves on the left side of the case.

The drawers consist of a large or deep drawer on the bottom that will be 7 1/4 inches tall, then two drawers on top of that with each being 5 inches tall or deep, then two drawers 4 inches deep and lastly two drawers that are 3 inches deep.

This tool cabinet is being built on four lockable casters 4 inches tall. I am following the Woodsmith Roll Around Tool Cabinet plan published in their Shop Notes Library.

-- --- Happy Howie

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics