George Pagliarulo's Forum Topics

  • Advertise with us
View George Pagliarulo's:homeworkshopprojects (0)blog (0)reviews (0)forum topics (7)buddies (0)favorites (0)activity logWatch
04-11-2020 10:44 PM

Delta Boss Spindle Oscillating Sander - 4 replies

Hi,Is this sander worth $100 used. Owner says it is in very good condition with extra spindles.

04-01-2020 08:00 PM

Question on turning crotch blank - 10 replies

Hi,A very dear friend of my wife died recently. This friend loved Birch trees. I want to turn memorial Birch bowls for my wife, two other close friends and the woman’s son. The photo shows three pieces that I want to use. Three of them are pretty straight forward to trim and get ready for turning. I have never turned anything with a crotch ...

01-25-2020 09:28 PM

Suggestions for turning this blank into a vase - 16 replies

About two years ago I had to cut down a large bush. I saved the base that looked like it would make an interesting vase. It’s been sitting in the shop ever since. What I would like to do is turn the outside up to the point that the branches come out then hollow out the center as much as possible. I’ll probably use a Forster bit to start holl...

03-26-2019 12:18 AM

I need a Delorean - 10 replies

I’ve discovered that my shop is some weird kind of time machine that must be accelerating time. I go down there, say, at 1:00 in the afternoon and spend what I figure is an hour or two. Yet, when I check my watch it says 6:30! Somehow, 3-1/2 hours have passed unaccounted for. Yet, when I come back upstairs I feel younger. See? Weird.

03-24-2019 10:23 PM

Grinding wheel not round - 11 replies

My new grinding wheel is not round. When I rotate it to start it slowly turning it always turns back and forth until the same heavy spot is at the bottom. I started to dress it to get it round but I’ve stopped because I figure it will sort itself out as I sharpen tools, so why take material off the wheel unnecessarily. Do you see any problem ...

01-14-2019 08:32 PM

Looking for a good saw set - 1 reply

Hi,I am looking for a saw set so that I can start sharpening my ip and crosscut saws. I’ve been looking for a Stanley 42X on Ebay. But haven’t found one I want yet. There are lots of other sets from other manufacturers but I don’t know which ones are worth having. Can anyone provide an nformation on what saw sets I should look at? As far as...

03-18-2018 08:49 PM

Shopsmith dado arbor and sawblades - 10 replies

Hi, this is for any Shopsmith owners. I have a Shopsmith, which is not my usual tablesaw, but now I need to use it. I had my SS blades sharpened and seem to have temporarily (I hope) misplaced the arbor. I have the dado arbor which has a 5/8 arbor. SS says that this arbor is not for saw blade use but I am in a bind. I don’t need to cut a lo...

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics