GeneFK's Blog

  • Advertise with us
This blog is written by GeneFK | 2 entries so far

Latest Entry

Installation of Faceframe Overlay Hinges without a face frame

03-21-2013 11:23 PM by GeneFK | 7 comments »

I am building a large, hanging jewelry case of my own design, although I have seen similar ones for sale in catalogs. The wood is walnut and the case is 13/16” thick & 5” deep. It is approximately 16” X 50” so the door can hold a standard 12” X 48” mirror. I purchased Liberty 1 1/4” Faceframe Overlay Hinges and a 35mm forester bit to drill the proper size hole in the door frame. My mirrored door frame is also walnut 13/16” X 2 1/4” and rabbeted to hold the mirror and backing board. I would drill the 35mm hole in the door frame along with the two adjacent 8mm screw holes and then drill small holes for the two tabs on the other ...

Read this entry »

Older Entries

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics