LumberJocks

GCWC's Forum Topics

  • Advertise with us
View GCWC's:homeworkshopprojects (47)blog (0)reviews (0)forum topics (5)buddies (0)favorites (1)activity logWatch
11-01-2020 01:19 AM

angles - 4 replies

looking for a chart or cheat sheet, that shows the different angles to cut for different number of sided boxes

01-13-2019 08:47 PM

scroll saws - 2 replies

I have seen a lot of different tables for scroll saws, and I’ve seen some where the back of the saws are lifted, putting the saw at an angle. what is the reason for this, what advantage is there for this?

12-11-2014 02:46 PM

Craftsman TS - 3 replies

I have a contractors Craftsman saw not sure of model, about 8 years old.the problem I have is when crank the handle for 45 degree angle cuts. After I get to about the 30 degree mark it is really hard to crank, I crank seem to find any where it is binding and the shaft turns straight. any ideas would be great, I don’t know if it&#...

12-11-2014 01:19 PM

cutting board - 8 replies

question people:I just cut a blood groove on a cutting board, and it seemed to burn pretty good, yeah I can sand it out, but what can I do to keep this from happening again.The groove is only about 1/4 inch deep, and made one pass, should I have taken baby steps? I don’t think speed was the issue, if I went slower it didn’t ma...

11-03-2014 07:43 PM

newbee - 0 replies

newbee here from Mi, been reading some of the post or blogs, and there are a lot of talented people here.I’ve been working with wood for about 15 years, and always up for a challenge.I’ve built walnut end tables, headboards, storage benches, cutting boards and even a decorative airplane prop that was about 5 feet long with hand carve...


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com