EugdOT's Forum Topics

  • Advertise with us
View EugdOT's:homeworkshopprojects (1)blog (0)reviews (0)forum topics (8)buddies (0)favorites (10)activity logWatch
05-11-2019 07:13 PM

Skill question - 9 replies

I’m making a box and want to add a draw in the middle. What’s the best method to cut out the piece from a center portion or off center and use it to for the draw front. So that once it’s complete it will still flow with the grain? Bandsaw, fine tool, table saw, and jig saw. I assume that I will have to glue the board back together. I just wa...

04-30-2019 02:53 AM

Question about grizzly go555lanv bandsaw - 6 replies

I bought my band saw a 4 few years and have not used it much making mostly cuts that were not safe with my table saw and recently wanted to start resawing more stock and getting more use out of it. I put a riser block on it right after purchasing it. I noticed that when I tighten the top screw on the unit that goes on to the elongated up and d...

12-06-2018 11:04 PM

Question on Stainley low angle jack plane? - 8 replies

Just got the number 62 low angle jack, came with a 25 degree blade. Would like to also get a 40 degree blade. Has anyone tried to use a wood river blade in it? I am ordering a few things from woodcraft and can pick one up in the order.

09-19-2018 04:37 PM

Double stacked crown molding? - 6 replies

I saw this and wondered how they stacked laters of crown. Then did a medallion of another double or triple stacked? Did they use crown or a base molding? Just looks so elegant

12-12-2017 03:04 AM

wainscoting stairs question? - 17 replies

I am in the planning stages of wainscoting my foyer to the stairs to my upstairs. My wife and I feel its going to look best total height of 36 with the top chair rail considering we have 8 foot ceiling for most of the house. I have run into a mind block and trying to figure a simpler way. where the down stairs foyer meets the stairs is 44 in...

04-07-2017 12:38 PM

Adjustment Hard stops on a sawstop - 17 replies

Has anyone adjusted the 45 degree hard stop on a pcs. Lately i been making small boxes for the holidays and for my kids. I just can’t seem to get all the corners mitered tightly. I have tried a bunch of things. I zeroed the miter gauge using garage woodworks dial indicator way. Used a backer on the miter gauge to increase stability. Hav...

12-31-2016 05:19 AM

Sawstop plug and outlet question - 6 replies

I finally got a chance and assembled the pcs my wife bought me for my birthday today, everything went smoothly except for 1 thing, my electrician thought it was a hardwire unit and just left a courd comming out of a electrical switch box from the subpanal. This is my question, I have a 60 amp subpanal with four 20 amp, 220v fuses, the sawst...

12-11-2016 02:40 PM

How to level The SawStop ICS base - 10 replies

I am getting my PCS sawstop next week and I received my ICS base today. I could not wait to open the box and check it out. I am having issues trying to figure out how I am going to level it. My shop is in my 2 car garage and the floor is sloped to the garage doors. I have a cheaper 70 dollar shop fox and I can level it out with knobs on the ...

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics