Cornhole Scoreboard w/ Beer Holder #2: The Finger Holes and Leg Design

  • Advertise with us
Blog entry by EdsCustomWoodCrafts posted 06-25-2015 05:48 PM 2161 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 1: Design & Materials Part 2 of Cornhole Scoreboard w/ Beer Holder series Part 3: Layout lines & Dowel Holes »

I thought this would be a nice touch in drilling 3 holes with an 1 3/8” forstner bit to give slots to carry the scoreboard, I centered the holes in the middle of the board,4” in from the left side and 2” down from the top. ( see below)

The defined the legs.. I measured in 2” from each side of the bottom of the board and 3” up creating the radius and then I just cut the semi circle out, I clamped both boards together and did the cuts simultaneously… It defined the little less providing stability I just hope it’s enough to keep it standing .

-- Thanks Ed “A bad day woodworking is better than a good day working. ~Author unknown” . Come check out my website for more about what I make and how at

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics